Replacement Parts

Need to replace a few parts on your Sleep Cooling System?

Adjustable 12V Power Supply:  Our standard 12V 2 Amp power supply used for all of our pumps and fans. Converts AC power to DC rated for up to 240V and 50/60 HZ

Wire Splitter:  Primarily used for the Pro-splits incoming 12V power to run the fan and pump

Submersible Pump:  The is the standard 12V pump that we use in all of our systems. rated at 330 l/h and HMAX of 300cm. Of note... maxflow rating is at 0 cm lift...decreasing to 0 at 300 cm ...that's just how these work. For a standard bed and a floor placed cooler...lift needed is typically less than 100cm.
Mattress Cooler Pro Fan: 120mm 12V fan compatible with the Mattress Cooler Pro evaporative cooler.

Double Tubing Set:  9 feet of double tubing compatible with all of our systems. Use as a replacement if your cat ate yours or your robot vacuum chopped it in half.

Y Split Tube Connector:  Comes with one splitter and one small piece of tubing. Connect directly to the outlet of the pump to split the outgoing flow and run two pads. Reccomended for 2 pillow pads. As cooling pad surface increases, so does the cooling power required, so there is a limit.... If you go nuts and connect 4 mattress toppers to your 45W cooler.. it is going to struggle to keep the water under ambient air temperature. 

1 Mattress Topper+1 pillow pad is about the max for the 2 and 4 gallon Cold Flash systems. The Ultra can run 2 mattrress toppers.